TM 55-1520-240-23-9
11-168
REMOVE PITCH LINEAR TRANSDUCER
11-168
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Materials:
Paper Tags (E264)
Personnel Required:
Medium Helicopter Repairer
References:
TM 1-1520-253-23
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Hydraulic Power Off
Closet Acoustic Blanket Removed (Task 2-107)
Closet Backup Panel Removed (Task 2-2)
NOTE
Attaching bolts, washers, and nuts will
be temporarily installed after removing
transducer.
NOTE
If a crack in the bellcrank is
suspected during removal, refer to TM
1-1520-253-23.
1.
Tag and disconnect two connectors (1) from
receptacles (2) on structure (3).
2.
Remove cotter pin (4), nut (5), and washer (6)
from bolt (7) in support (8). Slide bolt outboard to
release pitch linear transducer (9). Disconnect
transducer from support.
3.
Install washer (6) and nut (5) loosely on bolt (7)
in support (8).
4.
Remove cotter pin (10), nut (11), two washers
(12), and bolt (13) from bellcrank (14). Remove
transducer (9).
5.
Install bolt (13), two washers (12), and nut (11)
loosely in bellcrank (14).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
11-684
