TM 55-1520-240-23-9
11-165
ADJUST DIFFERENTIAL AIRSPEED HOLD (DASH) ACTUATOR
(Continued)
11-165
10.
Align pointer (4) with line (11) on plate (2) and
hold position.
11.
Adjust rod end (19) until actuator (5) can be
positioned in bellcrank (18) with bolt (17) loosely
installed.
12.
Install bolt (17), two washers (15), bushing (16),
and nut (14) in bellcrank (18).
13.
Torque nut (14) to 30 inch-pounds. Continue
tightening only as needed to align cotter pin
holes. Do not exceed 45 inch-pounds.
14.
Install cotter pin (13).
15.
Check bolt (17). Bolt shall not rotate with torque
less than 10 inch-pounds. There shall be no
axial looseness. If bolt rotates or is loose, add
washer under nut and repeat steps 13 and 14.
INSPECT
11-679
