TM 55-1520-240-23-9
11-161
ASSEMBLE PITCH CCD ACTUATOR (AVIM)
(Continued)
11-161
1.
Install trim motor (1) in motor support. Align
wires (3) of motor and wires (4) of harness (5).
2.
Position clamp (6) on motor (1) and motor
support (2). Tighten nut (7).
3.
Solder wire (8) to lug (9). Use sleeving (E204),
solder (E360), and soldering gun. Remove tag.
4.
Solder three wires (10) to terminal board
(11). Use sleeving (E204), solder (E360), and
soldering gun. Remove tags.
5.
Solder two wires (12) to terminal board (13). Use
sleeving (E204), solder (E360), and soldering
gun. Remove tags.
6.
Position board (11) on chassis (14). Install two
screws (15) and washers (16) in chassis and
board.
7.
Position board (13) on chassis (14). Install two
screws (17) and washers (18) in chassis and
board.
8.
Solder seven wires (19) to terminals (20) of
receptacle (21). Use sleeving (E204), solder
(E360), and soldering gun. Remove tags.
9.
Position receptacle (21) on chassis (14). Install
two washers (22) and screws (23).
11-655
