TM 55-1520-240-23-9
11-80
RIG PILOT’S COCKPIT CONTROL ASSEMBLY
11-80
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Rigging Set, Controls (T39)
Torque Wrench, 5 to 50 Inch-Pounds
Torque Wrench, 30 to 150 Inch-Pounds
Scale, 6 Inch
Materials:
None
Parts:
Cotter Pins
Personnel Required:
Medium Helicopter Repairer
Inspector
References:
Task 1-13
Equipment Condition:
Off Helicopter Task
Rigging Fixture (T39) Installed (Task 11-22)
Do not drive rig pin in rigging hole.
Damage to component will result.
Do not lubricate rig pin. Lubrication
will cause accumulation of dirt at
rigging hole.
NOTE
Impedance bolts are installed in flights
control connections. These bolts are
self-retaining and require a special
nut and torque (Task 1-13).
RIG YAW CONTROL
1.
Insert rig pin (1) fully in rigging holes (2) in top
and bottom of support assembly (3), and through
yaw bellcrank (4). If pin slides freely, go to step
10. If pin does not slide freely, perform steps 2
thru 10.
11-414
