TM 55-1520-240-23-9
11-78
ASSEMBLE COPILOT’S COCKPIT CONTROL ASSEMBLY
(Continued)
11-78
156.
Position cylinder (317) in upper mount (318)
ports (319) forward.
157.
Install bolt (320), two washers (321 and 322), and
nut (323). Torque nut to 30 to 45 inch-pounds.
Install cotter pin (324).
158.
Position cylinder (317) in arm (14).
159.
Install bolt (325), two washers (326 and 327), and
nut (328). Torque nut to 30 to 45 inch-pounds.
Install cotter pin (329).
160.
Position cylinder (330) in upper mount (331),
ports (332) forward.
161.
Install bolt (333), two washers (334 and 335), and
nut (336). Torque nut to 30 to 45 inch-pounds.
Install cotter pin (337).
162.
Position cylinder (330) in arm (15).
163.
Install bolt (338), two washers (339 and 340), and
nut (341). Torque nut to 30 to 45 inch-pounds.
Install cotter pin (342).
164.
Rig control assembly (343) (Task 11-42).
165.
Torque two nuts (303 and 308) to 30 to 45
inch-pounds. Install two cotter pins (344 and
345).
166.
Check two bolts (300 and 305). Bolts shall not
rotate with torque less than 10 inch-pounds.
There shall be no axial looseness. If bolt rotates
or is loose, add washer under nut and repeat
step 165.
11-406
