TM 55-1520-240-23-8
10-114
INSTALL FUEL CROSSFEED VALVE
(Continued)
10-114
NOTE
There are two fuel crossfeed valves.
Procedure is same to install either
valve. No. 2 (right side) valve is
shown here.
1.
Position packing (1) and adapter (2) on valve (3).
2.
Install electrical lead (4), four bolts (5) and
washers (6). Lockwire bolts. Use lockwire
(E231).
3.
Remove plug from tee (7).
4.
Position packing (8) and valve (3) on tee (7).
Install four washers (9) and bolts (10). Lockwire
bolts (10). Use lockwire (E231).
5.
Install electrical lead (4) on adapter (11) with two
washers (12), bolt (13), and nut (14).
6.
Remove plug from hose connector (15). Install
packing (16) in hose connector.
7.
Connect hose connector (15) to adapter (2).
Torque hose connector to 1125 inch-pounds.
8.
Install clip (17), electrical lead (18), two washers
(19), screw (20) and nut (21).
9.
Connect electrical connector (22).
INSPECT
FOLLOW-ON MAINTENANCE:
Bleed fuel system (Task 10-121).
Perform operational check of fuel system (TM
55-1520-240-T).
Check for leaks (Task 10-4).
END OF TASK
10-490
