TM 55-1520-240-23-8
10-66
INSTALL FORWARD OR AFT FUEL TANK VENT ASSEMBLY
(Continued)
10-66
NOTE
Pipe assembly (40) must be
positioned so that no high or low
spots in the assembly can trap
fluids. Clamps and spacers must be
positioned to remove slack in hose
and ensure a level tube.
17.
Remove tags from three spacers (57) and
position as indicated.
18.
Position three clamps (58). Install three washers
(59) and screws (60).
19.
Check that no high or low points occur in pipe
assembly (40).
20.
Remove tags and position hose (61) and ring
(62). Connect hose connectors (63 and 64).
21.
Position two clamps (65). Install two washers
(67) and screws (68).
22.
Connect hose connector (69). Position clamps
(70 and 71). Install screw (72), washer (73), and
nut (74).
23.
Remove tags and position hose (75). Connect
hose connectors (76 and 77).
24.
On forward fuel tank only, position two clamps
(78 and 79). Install two screws (80), washers
(81), and nuts (82).
25.
On forward fuel tank only, position two clamps
(83 and 84) and spacer (85). Install screw (86),
washer (87), and nut (88).
10-329
