TM 55-1520-240-23-7
9-124
ADJUST TROOP JUMP SIGNAL DIMMING RESISTOR
(Continued)
9-124
1.
Set caution light switch (1) to DIM.
2.
Set troop jump light switch (2) to GREEN.
3.
Remove two bolts (3) and washers (4) from panel
(5). Lower panel.
Do not touch wires or circuits when
adjusting resistors. Injury to personnel
can occur.
4.
Connect multimeter (6) to resistor terminal (7)
and aircraft ground (8).
5.
Loosen screw (9). Move slider band (10) until
multimeter (6) indicates 14 to 16 volts.
6.
Tighten screw (9). Disconnect multimeter (6).
9-474