TM 55-1520-240-23-7
9-98.2
INSTALL OVERHEAD PANELS IN PANEL
(Continued)
9-98.2
HYDRAULIC PANEL WITHOUT 65
14.
Install HYDRAULIC panel (121) as follows:
a.
Position panel (121) on panel (2). Tighten
four screws (122).
b.
Remove tape. Install ground wire (123)
on receptacle (124) with nut (124.1) and
lockwasher (124.2). Make sure wire terminal
is against metal panel. Remove tag.
c.
Remove tape. Connect 17 wires (125) to five
switches (126) and one receptacle (124) by
installing washers (127) and screws (128).
Remove tags.
HYDRAULIC PANEL WITH 65
14.1.
Install HYDRAULIC panel (121) as follows:
a.
Position panel (121) on panel (2). Tighten
four screws (122).
b.
Remove tape. Install ground wire (123)
on receptacle (124) with nut (124.1) and
lockwasher (124.2). Make sure wire terminal
is against metal panel. Remove tag.
c.
Remove tape. Connect 24 wires (125) to six
switches (126) and one receptacle (124) by
installing washers (127) and screws (128).
Remove tags.
INSPECT
NOTE
If no other panels are to be replaced,
go to step 15.
9-343
