TM 55-1520-240-23-6
7-174
DISASSEMBLE AND INSPECT ACCUMULATOR (60910) (AVIM)
7-174
INITIAL SETUP
Applicable Configurations:
All
Tools:
Hydraulic Repairer’s Tool Kit, NSN 5180-00-323-4891
Wood Dowel, 3/8 Inch X 9 Inches
Soft Jawed Vise
Technical Inspection Tool Kit, NSN 5180-00-323-5114
Outside Micrometer Caliper, 1 to 2 Inch
Telescoping Gage Set
Drift Pin, 1/16 Inch
Materials:
None
Personnel Required:
Aircraft Pneudraulics Repairer
Inspector
References:
Task 7-1.1
Equipment Condition:
Off Helicopter Task
NOTE
General inspection criteria (Task
7-1.1) for obvious damage applies
unless otherwise stated.
Inspection steps cover parts that are
subject to wear.
1.
Position housing (1) in vise (2).
2.
Remove two screws (3) from plate (4). Remove
plate.
Wear goggles when removing retainer
to prevent injury to eyes.
3.
Remove retainer (5). Align one end of retainer
and hole (6) in housing (1). Insert 1/16 inch
drift pin (7) through hole (6) and push end of
retainer inward. Insert thin bladed screwdriver
(8) between retainer and housing. Pry retainer
from housing. Use goggles for eyes.
4.
Remove housing (1) from vise (2).
7-724
