TM 55-1520-240-23-6
7-132
INSTALL AFT PIVOTING SERVOCYLINDER
(Continued)
7-132
NOTE
All overhauled actuators must have a
suffix "N" behind the serial number.
(Suffix "N" indicates the actuator has
been adjusted in accordance with TB
1-1520-240-20-85, this is not required
on new actuators.)
1.
Install tee (1) and packing (2) in servocylinder
(3). Do not tighten nut (4) at this time.
2.
Install tee (5) and packing (6). Do not tighten
nut (7) at this time.
3.
Install elbow (8) and packing (9). Do not tighten
nut (10) at this time.
4.
Install elbow (11) and packing (12). Do not
tighten nut (13) at this time.
5.
Install nipple (14) and packing (15).
6.
Install nipple (16) and packing (17).
7.
Slide clamps (18 and 19) on servocylinder (3).
8.
Connect tube (20) to tee (1) and nipple (14).
9.
Align clamp (18) and clamp (21). Install screw
(22), two washers (23), spacer (24), and nut (25).
Tighten nut (4).
10.
Connect tube (26) to tee (5) and nipple (16).
11.
Align clamp (19) and clamp (27). Install screw
(28), two washers (29), spacer (30), and nut (31).
Tighten nut (7).
7-595
