TM 55-1520-240-23-6
7-129
REPAIR PIVOTING SERVOCYLINDER (AVIM) (Continued)
7-129
MOUNTING LUGS AND VALVE AND CYLINDER
HOUSINGS
12.
Remove nicks, scratches, corrosion and pitting
by filing, burnishing, honing, polishing, or hand
stoning within the following limits:
a.
Repair of mounting lugs (14 and 20), valve
(21), and cylinder (22) housing surfaces must
not be more than a depth of 0.040 inch or
10 percent of material thickness, whichever
is less.
b.
Repaired areas must clear holes and radii a
minimum of 0.750 inch.
WARNING
Cadmium solution (E361) is extremely
toxic. It can irritate skin and cause
burns. Use only with adequate
ventilation. Do not inhale. Do not
contact eyes, skin, or clothing. In
case of contact, immediately flush
skin or eyes with water for at least
15 minutes. Get medical attention
for eyes.
13.
Apply cadmium solution (E361) (Spec QQ-P-416)
with brush (E86) on repaired surfaces (14, 20,
21, and 22). Wear gloves (E184.1).
WARNING
Alodine (E65) is an oxidizer. Discard
cloths which contain this material in a
separate container. If discarded with
cloths contaminated with acetone,
MEK, or other organic solvents,
combustion can result. In case of
contact, immediately flush skin or eyes
with water for at least 15 minutes.
Get medical attention for eyes.
14.
Apply alodine (E65) (Spec MIL-C-5541) to end
caps (23) and spring housing (24) damaged
surfaces. Wear gloves (E184.1).
7-580
