TM 55-1520-240-23-6
7-113
REMOVE NO. 1 OR NO. 2 FLIGHT CONTROL RESERVOIR/COOLER
(Continued)
7-113
NOTE
Procedure is same to remove No. 1
or No. 2 flight control reservoir/cooler.
Removal of No. 2 reservoir/cooler is
shown here.
1.
Loosen clamp (1) on hose (2). Disconnect hose
from tee (3). Use gloves (E186).
2.
Open valve (4) and drain reservoir/cooler (5).
Use container and cloths (E135) for spilled fluid.
3.
Close valve (4). Connect hose (2) to tee (3).
Tighten clamp (1).
4.
Loosen clamp (6). Slide clamp on duct (7).
Disconnect duct from reservoir/cooler (5).
5.
Loosen clamp (8). Slide clamp on hose (2).
Disconnect hose from valve (4).
6.
Tag and disconnect three tubes (9).
7.
Tag and disconnect three electrical plugs (10).
7-517