TM 55-1520-240-23-6
7-104.2
TEST ILCA JAM SENSORS — PHASE II
(Continued)
7-104.2
NOTE
This task is to be followed if suspect
ILCA fails PHASE I TEST (Task
7-104.1) and no replacement ILCA is
available or field requirements do not
allow for immediate replacement.
1.
Set FLT CONTR switch (1) to BOTH.
2.
Set AFCS SYSTEM SEL switch (3) to OFF.
3.
DEPRESS and HOLD centering device release
switch (4) on cyclic stick (2) while inspecting the
suspect roll, pitch or yaw ILCAs as follows.
4.
Grasp input control rod (5) to the suspect ILCA
and move it up and down.
5.
Observe that the control valve lever on the side
of the ILCA housing moves freely between the
machined mechanical stops.
NOTE
Motion must exhibit NO binding and
POSITIVELY contact the mechanical
stops by solid feel. If condition exists,
proceed to step 10 and perform
remaining task steps.
6.
Release the centering device release switch (4)
on the cyclic stick (2).
7-497
