TM 55-1520-240-23-6
7-333
BLEED UTILITY HYDRAULIC WINCH SYSTEM
(Continued)
7-333
Filter assembly kit
ADHT6814-M9716M must be
installed in test stand pressure
lines. Otherwise, system can be
contaminated.
NOTE
To operate hydraulic test stand, refer
to applicable manual.
1.
Disconnect drain hose (1) from winch motor (2).
2.
Loosen nut (3) of elbow (4). Remove elbow,
packing (5), and washer (6).
3.
Fill motor (2) through port (7) with fluid (E199).
Tap motor with hammer soft-faced to remove
trapped air.
4.
Install washer (6) and packing (5) on elbow (4).
5.
Install elbow (4). Do not tighten nut (3) at this
time.
7-1227