TM 55-1520-240-23-5
6-14
REMOVE FORWARD DRIVE SHAFT MOUNT
(Continued)
6-14
Do not allow bolt to turn. If bolt turns,
it can damage bolt and plates.
NOTE
Remove left or right mount at any of
six places in same way. Typical right
mount is shown here.
1.
Hold head of one bolt (1) in plates (2). Keep
bolt from turning and remove nut (4) and special
washer (5). Remove bolt and special washer (6).
2.
Rotate plates (2) to align hole (7) with lower of
two mounting bolts (8).
NOTE
Reach lower bolt on drive shaft mount
through bolt hole in plates. Use socket
and extension.
3.
Remove nut (9), two washers (10), and bolt (8)
from top and bottom of mount (11). Remove thin
washer (12) from between mount and support
(13).
4.
Rotate plates (2) to align hole (7) with mount
bushing (14).
5.
Support shaft (15) with cloths (E120) or barrier
material (E80) (16).
NOTE
Reach center bolt on mount through
bolt hole in plates. Use socket and
extension.
6.
Remove nut (17) and washer (18) from bushing
bolt (19). Remove bolt and washer (20).
6-43
