TM 55-1520-240-23-5
6-185
INSPECT COMBINING TRANSMISSION OIL COOLER FAN DRIVE SHAFT SNUBBER
6-185
INITIAL SETUP
Applicable Configurations:
All
Tools:
Workstand
Materials:
None
Personnel Required:
Medium Helicopter Repairer
Inspector
References:
TM 55-1520-240-23P
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Combining Transmission Oil Cooler Fan and Drive
Shaft Removed (Task 6-182)
Cargo Ramp Open and Level (Task 2-2)
1.
Lift snubber (1) from around end of output shaft
(2).
2.
Check snubber (1) for cuts, tears, and erosion
of seating surface (3). There shall be no such
damage.
3.
Install snubber (1) over end of output shaft (2).
Make sure snubber is fully seated.
INSPECT
FOLLOW-ON MAINTENANCE:
Install combining transmission oil cooler fan drive
shaft and fan (Task 6-186).
Close cargo ramp (Task 2-2).
END OF TASK
6-605
