TM 55-1520-240-23-5
6-186
INSTALL COMBINING TRANSMISSION OIL COOLER FAN AND SHAFT 145D5319-3 OR
-5 (Continued)
6-186
9.
Install retaining shield (21) and shaft (10) as
follows:
a.
Coat shield mounting studs (22) with oil
(E253, E254, or E254.1). Insert shield (21)
into the cavity in sump (23) and lower it onto
studs. Keep beveled end of shield flange (24)
forward.
b.
Insert small blocks of wood, or equivalent,
between seal retainer (25) and shield (21)
high enough to raise the shield so that the top
of snubber (18) can be seen.
c.
Check that snubber (18) is firmly seated.
d.
Install packing (13) at each end of shaft (10).
Take note of the spotfaces on shaft (10). Do
not disturb grease on shaft.
NOTE
Rocking the shaft, in the direction
of the spotfaces, while applying
downward hand pressure will help to
seat it against the snubber.
e.
Install shaft (10) through sump (23) into the
transmission. Alternately apply and relax
hand pressure on the shaft until balance
flange (19) contacts snubber (18). Check
under shield (21) to ensure contact.
6-609
