TM 55-1520-240-23-5
6-105
ASSEMBLE (BUILD UP) LEFT ENGINE TRANSMISSION
6-105
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Source of Low-Pressure Compressed Air
Materials:
Dry Cleaning Solvent (E162)
Cloths (E120)
Gloves (E186)
Parts:
Preformed Packings
Personnel Required:
Medium Helicopter Repairer
Inspector
References:
TM 55-1520-240-23P
1.
Position transmission with output shaft (1) facing
left.
2.
Check that barrel nuts (2) and retainers (3) are
securely installed.
Dry cleaning solvent (E162) is
flammable and gives off toxic fumes.
It may irritate skin and cause burns.
Use only in well-ventilated area away
from heat and open flame. In case
of contact, immediately flush skin
or eyes with water for at least 15
minutes. Get medical attention for
eyes.
3.
Clean union (4) and elbow (5). Use dry cleaning
solvent (E162) and cloths (E120). Wear gloves
(E186). Dry with low pressure compressed air.
4.
Install union (4) and packing (6) in port (7).
5.
Install nut (8) on elbow (5). Install elbow and
packing (9) in port (10), with elbow pointing down.
6-418
