TM 55-1520-240-23-5
6-92
REMOVE AFT TRANSMISSION
(Continued)
6-92
REMOVE NUTS
NOTE
Torque shaft and torque adapter are
part of torque adapter assembly
(T160).
To avoid binding during transmission
removal, centerline of adapter shall
be directly under or slightly left of
transmission centerline.
26.
Install torque adapter (65) between structure (66)
at sta. 534 and structure (67) at sta. 594. Flat
side of base (68) shall face aft. Center adapter
under transmission (3) and tighten four hand
knobs (69). Make sure centerline of adapter is
not right of transmission centerline.
Make sure ratchet selector on torque
pack is set to NUT OFF before
applying torque. Changing ratchet
settings with torque applied can
damage unit and cause injury to
personnel.
27.
Set ratchet selector (70) on torque pack (T23)
(71) to NUT OFF.
NOTE
Adapter is part of torque pack (T23).
28.
Install adapter (72) in torque pack (T23) (71).
Install torque pack on support (73) with two
hooks (73.1). Make sure two pins (74) on bottom
of torque pack engage holes in support. Check
that torque indicator (74.1) faces aft and inboard.
28.1.
Secure torque pack (71) to support (73). Use two
thumb screws (74.2).
6-347
