TM 55-1520-240-23-4
5-30
REMOVE VERTICAL HINGE PIN OIL MANIFOLD TUBE
(Continued)
5-30
NOTE
Procedure is same to remove any
vertical hinge pin oil manifold tube.
1.
Remove two bolts (1), washers (2), and lightning
protection cables (3) from oil manifold tube (4).
2.
Remove lockwire from lower end of oil manifold
tube (4). Remove nut (5) and bracket (6).
Do not damage bore of pitch housing
when removing oil manifold tube. This
can cause damage to packings during
tube installation.
3.
Remove tube (4) and four packings (7) as follows:
a.
Push tube (4) straight up until bracket (8) is
clear of housing (9). Use rawhide mallet if
needed.
b.
Pull bracket (8) and tube (4) straight up out of
housing (9).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
5-150