TM 55-1520-240-23-3
3-32
INSTALL AFT LANDING GEAR
3-32
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Torque Wrench, 0-160 Foot-Pounds
Torque Wrench, 30-150 Inch-Pounds
Torque Wrench, 100-750 Inch-Pounds
Socket, 1-1/16 Inch
Socket, 1-1/8 Inch
Socket, 1-1/2 Inch
Blocks
Eddy Current Inspection Unit
Materials:
Dry Cleaning Solvent (E162)
Grease (E190)
Cloth, Cleaning (E120)
Gloves (E186)
Goggles (E473)
Parts:
Cotter Pins
Personnel Required:
CH-47 Helicopter Repairer (2)
Inspector
References:
Task 1-24
TM 1-1520-253-23
TM 55-1520-240-23P
WARNING
Dry cleaning solvent (E162) is
flammable and gives off toxic fumes.
It may irritate skin and cause burns.
Use only in well-ventilated area, away
from heat and open flame. In case
of contact, immediately flush skin
or eyes with water for at least 15
minutes. Get medical attention for
eyes.
NOTE
This procedure can be used for left
and right gear. Except for differences
noted in task. Right gear is shown
here.
1.
Clean trunnion (1) and shock strut attachment
fitting (2). Use cloth (E120) damp with dry
cleaning solvent (E162). Use gloves (E186).
Change 1
3-81
