TM 55-1520-240-23-3
4-42
REPAIR CONNECTING LINK (DRAG STRUT) AND ENGINE MOUNT FITTINGS (AVIM)
4-42
INITIAL SETUP
Applicable Configurations:
All
Tools:
Mechanical Puller
Micrometer Depth Gage
Outside Micrometer Caliper, 0 to 1 Inch
Staking Tool (T109)
Vernier Caliper
Arbor Press
Installation Bar (APP E-123)
Materials:
Brush (E85)
Cloths (E135)
Chalk (E110)
Kevlar Gloves (E187)
Epoxy Primer (E292)
Carbon Dioxide (Dry Ice) (E92)
Gloves (E184.1)
Sealant (E328)
Steel, Bar (E367)
Parts:
Bushings
Bearing
Personnel Required:
Machinist
Inspector
References:
TM 55-1520-240-23P
TM 1-1500-204-23
TM 55-1500-322-24
Equipment Condition:
Connecting Link Removed (Task 4-40 Without 74 ,
Task 4-40.1 With 74 )
General Safety Instructions:
Epoxy primer (E292) is flammable
and very toxic. It can irritate skin
and cause burns. Protective clothing
or body suit with respirator and eye
protection is required if material is to
be applied by spraying. Use only in
well-ventilated area away from open
flame and excessive heat. In case
of contact, immediately flush skin or
eyes with plenty of water for at least
15 minutes. Get medical attention
for eyes.
Carbon dioxide (dry ice) (E92) causes
severe burns and may be toxic. Use
only in well-ventilated area. Do not
get in eyes, on skin or clothing. In
case of contact, immediately flush
skin with plenty of water for at least
15 minutes. Get medical attention
for eyes.
4-220
