TM 55-1520-240-23-3
4-42
REPAIR CONNECTING LINK (DRAG STRUT) AND ENGINE MOUNT FITTINGS
(AVIM)
(Continued)
4-42
a.
If necessary, grind inside surface (28) of
bushing (27) in link (3) to expose end of
lockpin (29).
b.
Remove lockpin (29) by driving lockpin
through link (3) into slot of bushing (27).
Use drift (30). Cut off lockpin about halfway
into slot and continue driving until lockpin is
removed.
c.
Remove bushing (27) from link (3).
NOTE
Slot in bushing (27) must be parallel
to centerline of hole (31) and slot of
other bushing (32) within 1/4º.
d.
Install new bushing (27) in link (3). Use bar
(APP E-123) (33) and vise (34).
4-225