TM 55-1520-240-23-3
4-11.3
REPAIR OF ENGINE ELECTRICAL HARNESS
(Continued)
4-11.3
41.
Replace conduit section D, E, F, G, or H as
follows:
a.
Loosen conduit nuts (1) from affected junction
and connector elbow (3) or adapter (2).
b.
Loosen elbow (3) or adapter (2) from
connector.
c.
Pull elbow (3) or adapter (2) back, and
remove connector from end of affected
branch of harness (steps 1 thru 6).
d.
Slide off damaged conduit assembly.
e.
Slide on new conduit assembly, with
applicable ID tag.
f.
At connector end of conduit, pull back conduit
to gain access to end of wires. Make sure
enough wire extends from conduit to allow
installation of connector fitting and connector.
g.
Slide elbow (3) or adapter (2) over
wiring and install wiring in connector (TM
55-1500-323-24). Remove tags.
h.
Apply sealant (E340.2) to threads of affected
elbow (3) or adapter (2) and connector and
around wiring at each end of conduit.
i.
Position nylon washers (14) and tighten
conduit nuts (1) at elbow (3) or adapter (2)
and at other end of conduit.
j.
Tighten elbow (3) or adapter (2) at connector.
INSPECT
FOLLOW-ON MAINTENANCE:
Test harness (Task 4-11.2).
END OF TASK
4-92
