TM 55-1520-240-23-3
4-11.3
REPAIR OF ENGINE ELECTRICAL HARNESS
(Continued)
4-11.3
39.
Replace conduit section B as follows:
a.
Remove conduit section A (step 38).
b.
Identify wires which travel through conduit
section B and separate them from taped
harness covered by conduit section A.
NOTE
With 43 , Y junction and conduit
sections preceding and following Y
junction are replaced by a single
conduit between two coned junctions.
c.
Loosen section B conduit nuts (1) at plate
(15) and Y junction.
d.
Pull back conduit at coned junction and
carefully pull section B wiring through coned
junction plate (15).
e.
Pull off conduit section B.
f.
Clean wiring as necessary and wrap with
Teflon tape (E399) where covered by conduit
section B.
g.
Slide wires through new conduit section B
and existing coned junction plate (15).
h.
Apply a generous coat of sealant (E340.2) to
threads (16) of coned junction plate, threads
(17) of Y junction, and around wiring at each
end of conduit.
i.
Position nylon washers (14) and tighten
conduit section B coupling nuts (1).
j.
Install conduit section A (step 38).
4-90
