ADJUST FORWARD OR AFT CARGO HOOK SWITCHES (AVIM) (Continued)

ADJUST FORWARD OR AFT CARGO HOOK SWITCHES (AVIM) (Continued) - TM-55-1520-240-23-10_563

ADJUST FORWARD OR AFT CARGO HOOK SWITCHES (AVIM) (Continued) - TM-55-1520-240-23-10_565

TM-55-1520-240-23-10 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
525

TM 55-1520-240-23-10 16-28 ADJUST FORWARD OR AFT CARGO HOOK SWITCHES (AVIM) (Continued) 16-28 LOAD-BEAM OPEN SWITCH ADJUSTMENT Load-beam is spring loaded closed. Be careful when opening or closing load-beam, to prevent injury to personnel. 19. Rotate knob (17) counterclockwise. Rotate and hold load beam (15) open. Release knob. Reset latch (29) to closed position. Release load beam. Load beam shall rest on bottom of latch. 20. Connect multimeter (22), set to RX1 scale, between pins B and F of connector plug (23). 21. Remove lockwire and loosen two screws (30) and nuts (31). 22. Move load-beam-open switch (20) toward actuator arm (21) as far as it will go. 23. Move load-beam-open switch (20) away from actuator arm (21) until multimeter (22) reads 0 ohm. 24. Tighten two screws (30) and nuts (31). 25. Rotate knob (17) counterclockwise. Load beam (15) shall return to closed and latched position. Release knob. Check multimeter (22) reading. Multimeter shall read infinity. 26. Rotate knob (17) counterclockwise. Rotate and hold load beam (15) open. Release knob. Reset latch (29) to closed position. Release load beam. Load beam shall rest on bottom of latch. Check multimeter (22) reading. Multimeter shall read 0 ohm. 27. Rotate knob (17) counterclockwise. Load beam (15) shall return to closed and latched position. Release knob. Check multimeter (22) reading. Multimeter shall read infinity. 28. Torque screws (30) and nuts (31) to 15 inch-pounds. Lockwire screws. Use lockwire (E227). 29. Disconnect multimeter (22) from connector plug (23). 16-156

Privacy Statement
Press Release
Contact