TM 55-1520-240-23-10
16-26
INSTALL FORWARD OR AFT CARGO HOOK THREADED INSERTS (AVIM)
(Continued)
16-26
NOTE
Procedure is not same to install
inserts in front or rear cover. If 1/4-28
insert in front cover is to be installed,
go to step 1. If 10-32 or 1/4-28 insert
in rear cover is to be installed, go to
step 10. If 6-32 insert in rear cover is
to be installed, go to step 22.
INSTALL 1/4-28 INSERT IN FRONT COVER
1.
Clean any debris from hole (1) in front cover
(2). Use dry cleaning solvent (E162) and low
pressure air. Wear gloves (E184.1) and goggles.
Epoxy primer (E292) is flammable
and toxic. It can irritate skin and
cause burns. Use only with adequate
ventilation, away from heat or open
flame. Avoid contact with skin, eyes,
or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
2.
Coat hole (1) with epoxy primer (E292). Use
brush (E86). Wear gloves (E184.1).
3.
Position insert (3) on tool TD428L (4).
4.
Install insert (3) in hole (1) while primer is wet.
5.
Remove tool (4) from insert (3). Turn tool over,
180º and set over protruding keys (5) of insert.
6.
Drive down keys (5). Use arbor press or hammer.
7.
Remove tool (4).
16-135
