TM 55-1520-240-23-10
16-24
DISASSEMBLE AND INSPECT FORWARD OR AFT CARGO HOOK (AVIM)
(Continued)
16-24
48.
Remove plunger (100) and bushing (101) from
rear plate (66).
48.1.
Turn bearing (102) at end of plunger (100).
Wheel shall turn smoothly, with no sticking or
binding.
49.
If bearing (102) sticks or binds, remove cotter
pin (103), washer (104), clevis pin (105), and
bearing (102) from plunger (100).
50.
Remove two nuts (106), washers (107), and
packings (108). Do not remove solenoid (109) at
this time.
Solenoid and spring adjustment plate
must not separate. Solenoid spring
tension setting will be destroyed if
separation occurs.
51.
Separate plate (110) from gasket (111). Use
knife.
52.
Remove solenoid (109) with spring adjustment
plate (110).
53.
Remove gasket (111) from shaft support (112).
54.
Remove shaft support (112). Tap out support
from inside rear plate (66). Use soft faced
hammer.
55.
Remove retainer (113) and seal (114) from shaft
support (112).
56.
Remove gasket (115).
16-129
