TM 55-1520-240-23-10
16-8.2
REMOVE SUPPORT BEAM BUSHINGS
16-8.2
INITIAL SETUP
Applicable Configurations:
All
Tools:
Blind Hole Puller Set, NSN 5120-01-008-7974
Materials:
None
Personnel Required:
Medium Helicopter Repairer
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Center Cargo Hook Removed (Tasks 16-4 Without
35 and 16-4.1 With 35 )
1.
Install a 1 inch collet (1) through bushing (2) to
be removed.
2.
Thread actuator pin (3) into collet (1). Turn pin to
expand flange of collet behind bushing (2).
Do not hit beam with slide hammer
assembly. Beam can be damaged.
3.
Screw slide hammer assembly (4) into pin (3).
Use hammer to pull bushing (2) from beam (5).
4.
Repeat steps 1 thru 3 for remaining bushing (6).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
16-86
