• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL AFT BELLCRANK  STA 482 (Continued)
INSTALL  AFT  BELLCRANK  STA  482 (Continued) - TM-55-1520-240-23-9_991

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  956    957    958    959    960  961  962    963    964    965    966  
TM  55-1520-240-23-9 11-251 INSTALL  AFT  BELLCRANK  STA  482 (Continued) 11-251 4. Install  washer  (6)  and  nut  (7).  Torque  nut  (7)  to 250  inch-pounds. 5. Install  bolt  (8).  Hook  dial  indicating  scale  (9)  to bolt  (8). 6. Apply  force  to  bellcrank  (1)  with  scale  (9)  at  90º to  arm  (10).  Bellcrank  shall turn,  bolt  (3)  shall  not turn.  Force  shall not  exceed  3  pounds. Do  not  reduce  torque  to  less  than  100 inch-pounds;  otherwise,  damage  to components  will  result. 7. If  bolt  (3)  turns,  reduce  bolt  torque  by  5 inch-pounds repeat  step  6. 8. Install  cotter  pin  (11). 9. Remove  scale  (9)  and  bolt  (8). 10. Slide  cover  (12)  over  access  (5). Primer  (E299)  is  flammable  and  toxic. It  can  irritate  skin  and  cause  burns. Use  only  in  well-ventilated  area,  away from  heat  and  open  flame.   In  case of  contact,  immediately  flush  skin or  eyes  with  water  for  at  least  15 minutes.   Get  medical  attention  for eyes. 11. Have  outside  helper  coat  five  screws  (13)  with primer  (E299).  Install  screws  while  primer  is  wet. Wear  gloves  (E186). 12. Have  helper  hold  heads  of  five  screws  (13). 13. From  inside  helicopters,  install  five  washers  (14) and  nuts  (15). Sealant  (E336)  can  irritate  skin  and cause  burns.  Avoid  contact  with  skin, eyes,  and  clothing.  In  case  of  contact, immediately  flush  skin  or  eyes  with water  for  at  least  15 minutes.   Get medical  attention  for  eyes. 11-974







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.