• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL BELLCRANK  SUPPORT FITTINGS  STA 482
REMOVE  AFT FUSELAGE  LEFT CONNECTING  LINK

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  960    961    962    963    964  965  966    967    968    969    970  
TM  55-1520-240-23-9 11-251.2 INSTALL  BELLCRANK SUPPORT FITTINGS  STA  482 (Continued) 11-251.2 1. Clean  fittings  (1  and  2)  and  structure  with solvent  (E162).  Use  cloths (E120).  Wear  gloves (E184.1)  and  goggles. NOTE If aft  support  is new,  line-drill  to  hole pattern  in  structure. 2. Apply epoxy primer  (E292)  to  fitting  surfaces  and all bolts.  Wear  gloves (E184.1)  and  goggles. 3. With  helper,  position  forward  support  (1)  and  aft support  (2). 4. Install  wet,  three  washers  (3),  three  bolts  (4), nine  washers (5), and  three  nuts (6).  Tighten  nut (6),  but  do  not  torque. 5. Install  wet,  five  washers (7), five  bolts (8), fifteen washers  (9),  and  five  nuts  (10).   Tighten  nuts (10),  but  do  not  torque. 6. Install  wet, washer  (11),  bolt  (12), two  washers (13),  and  nut (14).   Tighten  nut (14),  but  do  not torque. 7. Install  wet,  two  washers (15),  two  bolts (16), four washers  (17),  and  two  nuts (18).   Tighten  nuts (18),  but  do  not  torque. 8. Install  wet,  two  washers  (19),  two  bolts (20),  two washers  (21),  and  two  nuts (22).   Tighten  nuts (22),  but  do  not  torque. 9. Install  wet,  washer  (23),  bolt (24), three  washers (25),  and  nut (26).   Tighten  nut (26),  but  do  not torque. 10. Torque  nuts (10, 22, and  26)  to  87  inch-pounds. 11. Torque  nuts (6,  14,  and  18)  to  172  inch-pounds. INSPECT FOLLOW-ON  MAINTENANCE: None END  OF  TASK 11-978







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.