• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
RIGGING
INSTALL COCKPIT RIGGING  FIXTURE,  STICK  YOKE,  PEDAL  PIN  AND THRUST PIN (Continued)

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  75    76    77    78    79  80  81    82    83    84    85  
TM  55-1520-240-23-9 11-22 INSTALL COCKPIT RIGGING FIXTURE, STICK YOKE, PEDAL PIN  AND THRUST PIN 11-22 INITIAL  SETUP Applicable  Configurations: All Tools: Aircraft Mechanic’s  Tool  Kit,  NSN  5180-00-323-4692 Cockpit  Controls Rigging  Tools (T39) Materials: None Personnel  Required: Medium  Helicopter Repairer Inspector References: Task  11-42 Equipment  Condition: Battery Connected  (Task  1-39) Electrical  Power  On Hydraulic  Power On Copilot’s or Pilot’s Floor Panels Removed  (Task  2-81) Copilot’s or Pilot’s  Seats Fully Aft  (Task 2-115) AFCS  SYSTEM  SEL  Switch  Set  to  OFF Do  not remove  hydraulic  power while rigging  tools  are  installed;  otherwise, damage  to  components will occur. NOTE Procedure  is  same  to  install  pilot’s or  copilot’s  cockpit  rigging  fixture, stick yoke, pedal  pin, and  thrust pin. Copilot’s rigging  tools are  shown  here. INSTALL  RIGGING  FIXTURE 1. Position  fixture  (1) on  copilot’s  cockpit  assembly (2) with  arm  (3)  of  fixture  to  right. 2. Align  fixture  (1) with  holes in  assembly (2).  Install four  bolts (4)through  fixture  and  in  assembly. INSPECT 11-82







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.