• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REMOVE DAMAGED  RIG PIN FROM  SECOND STAGE  CONTROLS (Continued)
INSTALL COCKPIT RIGGING FIXTURE, STICK YOKE, PEDAL PIN  AND THRUST PIN

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  74    75    76    77    78  79  80    81    82    83    84  
TM  55-1520-240-23-9 11-21 RIGGING 11-21 INITIAL  SETUP Applicable Configurations: All Tools: As  Required Materials: None Personnel  Required: Medium  Helicopter Repairer  (2) Inspector References: Task  11-30 Task  11-28 Task  11-192 Equipment  Condition: As  Required Rotor  blades  can  seriously  injure personnel.  Make  sure  area  around helicopter  is clear  of  personnel  before moving  rotor blades. Do  not  apply  more  than  20  pounds to  cockpit  controls.   Damage  to component  can  result. Do  not  remove  hydraulic power with rigging  pins  installed.   Damage  to component  will  result. 1. Install  lead/lag  absorber  rigging  tool  (T72)  if rotary-wing  blades are  to  be  turned  (Task  11-30). NOTE Rotary-wing  blades  place  forces  on flight  controls. 2. Install  safety  blocks  (T31)  in  forward  and  aft servocylinders  to  lock-out  rotary-wing  blade forces  (Task  11-28). 3. If  flight  control  components  are  to  be disconnected,  disconnect  forward  and  aft servocylinder connecting  links  (Task 11-192). NOTE Springs  in  servocylinder valves  in down  position. FOLLOW-ON MAINTENANCE: As  Required END  OF  TASK 11-81







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.