TM 55-1520-240-23-9
11-233
INSTALL AFT LCT YOKE
(Continued)
11-233
12.
Check yoke (1) as follows:
a.
Apply force to lug (3). Use dial indicating
scale (19). Yoke must rotate with force not
greater than 80 pounds. Shaft (16) shall not
rotate in support (17).
b.
Gap between washer (18) and shoulder
bushing (20) shall not be less than 0.005
inch.
c.
There shall be no gap between bushing (21)
and bearing (22).
d.
There shall be no gap between bushing (23)
and bearing (24).
13.
Install cotter pin (25) in nut (14).
INSPECT
14.
Position bulkhead pocket (26) over opening in
bulkhead (27).
15.
Install two screws (28), four cable clamps (29)
and two spacers (30).
16.
Install seven screws (3) and washers (32).
11-908