• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL AFT LCT  YOKE BUSHINGS  (AVIM) (Continued)
INSTALL  AFT  LCT YOKE  BUSHINGS (AVIM) (Continued) - TM-55-1520-240-23-9_919

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  887    888    889    890    891  892  893    894    895    896    897  
TM  55-1520-240-23-9 11-232 INSTALL  AFT  LCT YOKE  BUSHINGS (AVIM) (Continued) 11-232 12. Remove  bushing  assembly (5  and 6)  from  dry ice and  wipe  clean  and  dry.  Use  cloth  (E120).  Wear goggles  and  Kevlar  gloves  (E187). 13. Coat  outer  surface  of  bushing  (6)  with  epoxy primer  (E292).  Wear  gloves  (E184.1). 14. While  primer  is  wet  press bushing  assembly  (5 and  6)  into  upper  hole  of  lug  (2). 15. Allow  yoke  lug  (2)  to  cool. INSPECT 16. Turn  yoke  (4)  over  in  arbor  press  (11). Do  not  heat  yoke  over  230ºF (110ºC). Damage  to  shotpeened  surface  will result. 17. Heat yoke  lug  (3)  with  heat  gun.  Do  not  exceed 230ºF  (110ºC).  Use  pyrometer  to  measure temperature.  Wear  Kevlar  gloves  (E187). 18. Coat washer  (13)  with  epoxy  primer  (E292.1). 19. Place  washer  (13)  in  opening  in  lug  (3).   Align hole  in  washer  with  holes  in  lug. 20. Remove  bushing  (10)  from  dry  ice  and  wipe clean  and  dry.  Use  cloth  (E120).  Wear  goggles and  Kevlar  gloves  (E187). 21. Coat outer  surface  of  bushing  (10)  with  epoxy primer  (E292.1).  Wear  gloves (E184.1). 22. Insert  bushing  (10)  through  upper  hole  of lug  (3), through  washer  (13), and  into  lower  hole  of lug. Press bushing  fully  in. 11-902







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.