TM 55-1520-240-23-9
11-231
REMOVE AFT LCT YOKE BUSHINGS (AVIM)
(Continued)
11-231
7.
Remove slip fit bushing (9) from bushing (10).
Do not heat yoke over 230ºF (110ºC).
Damage to shotpeened surface will
result.
8.
Heat yoke lug (12) with heat gun. Do not exceed
230ºF (110ºC). Use pyrometer to measure
temperature. Wear Kevlar gloves (E187).
9.
Position large bushing (2) against outer surface
of lug (12). Wear Kevlar gloves (E187).
10.
Install bolt (3) through plate (4), bushing (2), lug
(12), and bushing (5). Install washer (6) and
nut (7).
11.
Tighten nut (7) to push bushings (13, 14, and
15) from lug (12).
12.
Remove nut (7), washer (6), bushing (5), bolt
(3), plate (4), and bushing (2). Remove bushings
(13, 14, and 15) from bushing (2).
13.
Remove large washer (16) from lug (12).
11-897