• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
CHECK LCT ACTUATOR  FOR SHAFT ROTATION
REPLACE  LONGITUDINAL CYCLIC  TRIM  (LCT) ACTUATOR VARIABLE  RESISTOR (AVIM) (Continued)

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  801    802    803    804    805  806  807    808    809    810    811  
TM  55-1520-240-23-9 11-205.1 REPLACE LONGITUDINAL CYCLIC TRIM (LCT) ACTUATOR VARIABLE RESISTOR (AVIM) 11-205.1 INITIAL  SETUP Applicable  Configurations: All Tools: Aircraft Electrical Tool  Kit,  NSN  5180-00-323-4915 Multimeter Materials: Lockwire  (E227) Epoxy Primer  (E292) Solder  (E360) Twine  (E433) Varnish  (E434) Insulation  Sleeving  (E204) Gloves  (E184.1) Personnel  Required: Aircraft  Electrician Inspector References: TM  55-1520-240-23P Equipment  Condition: Off  Helicopter  Task LCT  Actuator  Fully  Retracted 1. Remove  lockwire  from  cover  (1).  Remove  cover (1)  by turning  counterclockwise. 2. Inspect  inside  housing.  Check  that  the  resistor support  (2)  and  shim  washer  (3)  are  separate parts. a. If  resistor  support and  shim  washer  are  one part, install cover.  Send  actuator  to  overhaul. b. If  resistor  support  and  shim  washer  are separate  parts,  perform  steps  3  thru  20. 3. Remove  lockwire  and  insulating  sleeve  from screws (4).  Remove  two screws and two  washers (5). 4. Remove  resistor  support  (2)  with  shim  washer (3)  in  place.   Remove  shim  washer. 11-816







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.