• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REPLACE LONGITUDINAL CYCLIC TRIM (LCT) ACTUATOR VARIABLE RESISTOR (AVIM)
REPLACE  LONGITUDINAL  CYCLIC  TRIM  (LCT) ACTUATOR  VARIABLE  RESISTOR (AVIM) (Continued)

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  802    803    804    805    806  807  808    809    810    811    812  
TM  55-1520-240-23-9 11-205.1 REPLACE  LONGITUDINAL CYCLIC  TRIM  (LCT) ACTUATOR VARIABLE  RESISTOR (AVIM) (Continued) 11-205.1 5. Remove  spring  (6)  from  resistor  shaft  (7).   To remove  spring,  carefully twist  spring  to  loosen coils  and  withdraw  shaft. 6. Remove  lockwire  from nut  (8).  Remove  nut. 7. Remove  resistor (9) from  support  (2). 8. Remove  string-tie  from  wires  (10).   Unsolder wires  at  resistor  pins  (11). 9. Solder  replacement  resistor  wires  (10).   Use solder  (E360). 10. String  tie  wires to  pin  4.  Use  twine  (E433). 11. Install  resistor  (9)  in  support  (2).  Make  sure  that resistor locator  pin  (12)  goes into  support locator hole  (13). Varnish  (E434) is flammable and  toxic. It  can  irritate  skin  and  cause  burns. Use  only with  adequate  ventilation, away from  heat  or open  flame.  Avoid contact  with  skin,  eyes,  or  clothing. In  case  of contact,  immediately  flush skin  or  eyes  with  water for  at  least 15  minutes.   Get medical  attention for  eyes. 12. Install  nut  (8) on  resistor (9).   Secure  nut  with lockwire  (E227).   If  nut has  no  hole  for  lockwire, secure  nut  with  varnish  (E434). 13. Install  spring  (6) on  resistor shaft (7).  To  install spring, twist  to  open  coils  and  insert  shaft. 14. Rotate  resistor (9) clockwise  one  full  turn. 11-817







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.