• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REMOVE  YAW,  THRUST, ROLL OR PITCH  VISCOUS  DAMPER  ARMS
INSTALL YAW,  THRUST,  ROLL OR PITCH VISCOUS  DAMPER ARMS (Continued)

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  592    593    594    595    596  597  598    599    600    601    602  
TM  55-1520-240-23-9 11-139 INSTALL YAW,  THRUST, ROLL OR PITCH VISCOUS  DAMPER ARMS 11-139 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN 5180-00-3234692 Torque  Wrench,  5  to  50  Inch-Pounds Materials: Pencil  (E271) Epoxy  Primer (E292) Sealant  (E327) Gloves  (E184.1) Parts: Cotter Pin Personnel  Required: Medium  Helicopter Repairer Inspector References: TM  55-1520-240-23P Task  1-13 NOTE Procedure  is  same  to  install  yaw, thrust, roll  and  pitch  viscous  damper arms.  Yaw damper arm is shown here. 1. If arm (1) is  a  replacement  slide  arm  on  shaft  (2), arm  forward  and  plate  (3) to  damper (4).   Rotate arm  fully  up  and  fully  down  then  position  arm about  mid-position.   Arm  shall  be  about 90º  to mounting  surface  (5) of  damper.  Mark  position  of arm  on  damper.  Use  pencil  (E271). 2. Remove  arm  (1) from  shaft  (2). 3. Remove  setscrew (6) from  plate  (3) on  arm  (1). 4. Align  marks  on  arm  (1) and  damper  (4).   Slide arm on  shaft  (2), plate  (3) to  damper (4) and  arm forward.   Install  washer (7) and  nut  (8) on  shaft. Remove  marks  from  arm and  damper. 11-603







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.