• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
DISASSEMBLE  AFCS CONTROL PANEL (AVIM)
DISASSEMBLE  AFCS  CONTROL PANEL (AVIM) (Continued) - TM-55-1520-240-23-9_1039

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  1001    1002    1003    1004    1005  1006  1007    1008    1009    1010    1011  
TM  55-1520-240-23-9 11-270 DISASSEMBLE  AFCS  CONTROL PANEL (AVIM) (Continued) 11-270 5. Remove  two  setscrews (5)  from  knob  (6). 6. Remove  knob  (6) from  rotary switch  shaft  (7). NOTE Be  careful  when  removing  illumination panel at lamp  receptacle  connector. 7. Remove  three  screws  (8). 8. Remove  front  illumination  panel  (9).   Use common  screwdriver to  pry  panel  loose  at  lamp receptacle  connector (10). 9. Remove  four screws (11). 10. Remove  four  support  rods  (12). 10.1. Inspect  tubing  (12.1)  covering  support rods (12). There  shall  be  no  chafing  or  burns. NOTE Procedure  to  remove  three  toggle switches  is  the  same.   CYCLIC TRIM-AUTO/MAN  switch  is  shown here. 11. Tag  and  disconnect 12  wires (13) by  removing  12 screws (14) and  washers  (15). 12. Remove  nut  (16) and  washer (17). 13. Remove  switch  (18) from  mounting  plate  (19). 14. Remove  locking  ring  (20) from  switch  (18). 11-1022







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.