• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL ENGINE  OIL PRESSURE  TRANSMITTER  AND  VIBRATION  ISOLATOR MOUNT (Continued) - TM-55-1520-240-23-7_67
INSTALL ENGINE  OIL PRESSURE  TRANSMITTER  AND  VIBRATION  ISOLATOR MOUNT (Continued) - TM-55-1520-240-23-7_69

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  44    45    46    47    48  49  50    51    52    53    54  
TM  55-1520-240-23-7 8-16.1 INSTALL  ENGINE  OIL PRESSURE  TRANSMITTER  AND  VIBRATION  ISOLATOR MOUNT (Continued) 8-16.1 5. Position mount (9) in  two  clamps (14).  Make  sure keyway (11) is  facing  up.  Make  sure  one  screw (12)  and  nut  (13) is  facing  up. 6. If transmitter (4) and  mount (9) is  not positioned as shown,  loosen  two  screws  (12) and  nuts (13) and  go  to  step  3. 7. Close  clamps  (14) and  install  two  nuts  (15) on t-bolts  (16). NOTE After tightening,  minor distortion  of mount  is  acceptable. 8. Tighten  nuts  (15)  until  one  to  three  threads  of t-bolt  (16)  show above  each  nut. 8-52







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.