• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL ENGINE OIL PRESSURE TRANSMITTER AND VIBRATION ISOLATOR  MOUNT
INSTALL  ENGINE  OIL PRESSURE  TRANSMITTER  AND  VIBRATION  ISOLATOR MOUNT (Continued)

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  43    44    45    46    47  48  49    50    51    52    53  
TM  55-1520-240-23-7 8-16.1 INSTALL ENGINE  OIL PRESSURE  TRANSMITTER  AND  VIBRATION  ISOLATOR MOUNT (Continued) 8-16.1 3. Insert transmitter (4)  in mount  (9).  Position as follows: NOTE The left hand  transmitter keyway must be  between  the 11 and 1  o’clock position after  installation. The right  hand transmitter  keyway must  be between the 5  and 7 o’clock position after  installation. In order to clear installation of clamp it may  be  necessary  to reposition  fuel lines. a. Rotate transmitter (4)  until  four  corners  of mounting  flange (8)  are  within four  square mount  holes  (10). b. Rotate transmitter  (4)  until  keyway  (11) and  two  screws  (12)  and  nuts  (13)  are approximately aligned as shown. c. Center  transmitter mounting flange (8) within square  mount  holes  (10). 4. Tighten  two screws (12) and nuts (13)  in mount (9). 8-51







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.