• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL COMBINING TRANSMISSION FORWARD OUTPUT SHAFT OIL SEAL
REMOVE  COMBINING TRANSMISSION AFT OUTPUT SHAFT OIL SEAL

TM-55-1520-240-23-5 CH-47D Heilcopter Manual
Page Navigation
  248    249    250    251    252  253  254    255    256    257    258  
TM  55-1520-240-23-5 6-67 INSTALL  COMBINING  TRANSMISSION  FORWARD  OUTPUT  SHAFT  OIL SEAL (Continued) 6-67 Wear  Kevlar  gloves  when  handling hot retainer.  Hot  retainer  can  cause burns. Do  not  heat  retainer  over  250ºF (120ºC).  Metal can  be  damaged. 2. Heat  retainer  (1)  to  230º  to 250ºF  (110º  to 120ºC). Use gun-type heater.  Check temperature with  pyrometer. 3. Install  packing  (2)  in  retainer  (1). 4. Install  seal  (3)  in  retainer  (1)’  flat  side  up.  Use aluminum  tube. 5. Install  retaining  ring  (4). Oil  (E254)  is  toxic.  It  can  irritate  skin and  cause  burns.  Avoid  inhaling.  Use only with  adequate  ventilation.  Avoid contact  with  skin,  eyes,  or  clothing. In  case  of  contact,  immediately  flush skin  or  eyes  for  at  least  15  minutes. Get medical  attention  for  eyes. 6. Coat packing  (5)  with  oil  (E254).  Install  packing on  retainer  (1). 7. Apply  light  coat of  grease  (E190)  to  lip  of  seal (3).   Apply  light  coat of  oil  (E254)  to  surface  of shaft  (6).  Install retainer  (1)  on  transmission  (7). 8. Install  four  washers  (8)  and  nuts  (9)  on  studs (10).  Torque  nuts  to  60 inch-pounds. INSPECT FOLLOW-ON  MAINTENANCE: Install  combining  transmission  forward  adapter assembly  (Task  6-8). Install  No.  7  drive  shaft (Task  6-19). Close  aft pylon  lower  fairing  (Task  2-2). Perform  ground  run  (TM  55-1520-240-10). END  OF  TASK 6-256







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.