• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL NO. 1  FLIGHT CONTROL HYDRAULIC  PUMP  DRIVE  SHAFT SEAL
INSTALL NO. 1 FLIGHT CONTROL HYDRAULIC PUMP DRIVE  SHAFT SEAL (Continued)

TM-55-1520-240-23-5 CH-47D Heilcopter Manual
Page Navigation
  143    144    145    146    147  148  149    150    151    152    153  
TM  55-1520-240-23-5 6-45 INSTALL NO. 1  FLIGHT CONTROL HYDRAULIC PUMP  DRIVE  SHAFT SEAL (Continued) 6-45 Dry  cleaning  solvent  (E162)  is flammable  and  toxic.   It  can  irritate skin  and  cause  burns.   Use  only  in well-ventilated  area, away  from  heat and  open  flame.   In  case  of contact, immediately flush  skin  or eyes  with water  for  at  least 15 minutes.   Get medical  attention  for eyes. 1. Clean  seal  retainer (1).  Use  dry cleaning  solvent (E162) and  cloths  (E120).  Wear  gloves (E186). Wear Kevlar gloves when  handling  hot retainer.  Hot  metal can  burn  hands. Do  not  heat  retainer  over  250ºF (120ºC). Heat can  damage  metal. 2. Heat  retainer  (1) to  230º  to  250ºF (110º  to 120ºC).  Use  gun-type  heater  and  pyrometer. Wear  Kevlar  gloves  (E187). Oil  (E254) is  toxic.  It can  irritate  skin and  cause  burns.  Avoid  inhaling.  Use only with  adequate  ventilation.  Avoid contact  with  skin,  eyes,  or  clothing. In  case  of contact,  immediately  flush skin  or eyes  for at least 15 minutes. Get medical  attention  for eyes. 3. Coat packing  (2) with  oil  (E254).  Install  packing in  retainer  (1). 4. Install  seal  (3) in  retainer  (1),  flat  side  up.  Use aluminum  tube. 5. Install  retaining  ring  (4). 6-147







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.