TM 55-1520-240-23-3
4-127
REMOVE REMOTE POSITIONING CONTROL BOX
4-127
INITIAL SETUP
Applicable Configurations:
Without 74
Tools:
Aircraft Mechanics Tool Kit, NSN 5180-00-323-4692
Materials:
None
Personnel Required:
Medium Helicopter Repairer
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Right Electrical Compartment Access Door Open
(Task 2-2), Or No. 1 Remote Positioning Box
Access Cover Removed (Task 2-2)
NOTE
Procedure is same to remove No. 1 or
No. 2 remote positioning control box.
Removal of No. 2 box is shown here.
Two types of boxes are used
(SYLZ7561-3 and SYLZ7561-4).
Procedure is same for both.
1.
Disconnect electrical connector (1) from box (2).
2.
Remove four screws (3) and washers (4).
3.
Remove box (2).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
4-431