• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL WINCH (Continued) - TM-55-1520-240-23-10_342
REMOVE  WINCH  WIRE  ROPE  CABLE (Continued) - TM-55-1520-240-23-10_344

TM-55-1520-240-23-10 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
  305    306    307    308    309  310  311    312    313    314    315  
TM  55-1520-240-23-10 14-10 REMOVE  WINCH WIRE  ROPE  CABLE 14-10 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN 5180-00-323-4692 Container,  Two  Quart Wooden  Block,  2  Inch  X  4  Inch  X 12  Inch Materials: Cloths  (E120) Gloves,  Wire  Handling  (E185) Personnel  Required: Medium  Helicopter Repairer (2) References: TM  55-1520-240-T Equipment  Condition: Battery Connected  (Task  1-39) Electrical  Power On Hydraulic  Power On Acoustic Blanket Removed from Heater Compartment (Task  2-208) Cockpit  Aft  Floor Panel  Removed  (Task 2-83) General Safety Instructions: Wear  wire  handling  gloves  when removing  wire  rope  (cable). Otherwise, injury to  hands can  result. NOTE Keep  tension  on  wire  rope  when reeling  wire  rope  out.  Wire  rope  will reel  out evenly and  will not  snarl. 1. Have  helper keep  slight pull  on  wire  rope  (1). Helper  must wear gloves  (E185). 14-35







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.