• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
DUSTY  ENVIRONMENT MAINTENANCE
COLD  ENVIRONMENT MAINTENANCE

TM-55-1520-240-23-1 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
  301    302    303    304    305  306  307    308    309    310    311  
TM  55-1520-240-23-1 1-85 DUSTY  ENVIRONMENT MAINTENANCE (Continued) 1-85 Do  not  saturate  cloth  (E120)  with solvent  (E161)  for  removal  of  solid deposits  on  flight  control components. Contaminants  can  be   washed into  bearings  resulting  in  injury  to personnel  and  damage  to  equipment. 1. Clean  flight  control  linkage  in  drive  shaft  tunnel area  as  required.  Use  dry  brush  or  low-pressure compressed  air.  If  necessary,  use  cloth  (E120) damp  with  solvent  (E161).   Remove  dirt,  sand, and  grit  from  bellcrank,  idler,  and  connecting  link bearing  areas.  Wear  gloves  (E186). 2. Clean  swashplates  in  area  of  slider  shaft.  Clean upper  boost  actuator  piston.  Clean  rotary  wing shock  absorber  piston.  Clean  landing  gear  shock absorber  pistons.  Use  dry  brush  or  low-pressure compressed  air.  If  necessary,  use  cloth  (E120) damp  with  solvent  (E161).  Wear  gloves  (E186). NO  BREAK  -  WORK  HARDER NO  BREAK  -  WORK  HARDER FOLLOW-ON MAINTENANCE: Close  forward  transmission  fairing  work  platforms (Task  2-2). Close  aft  pylon  work  platforms  (Task  2-2). Close  drive  shaft  tunnel  access  covers  (Task  2-2). Close  aft  landing  gear  access  panels  (Task  2-2). Install  protective  covers  (1-32). END  OF  TASK 1-312







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.