TM 55-1520-240-23-9
11-237
INSTALL TUNNEL CONNECTING LINKS
(Continued)
11-237
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only with
adequate ventilation, away from open
flame. In case of contact, immediately
flush skin or eyes with water for
at least 15 minutes. Get medical
attention for eyes.
14.
With 38 , clean inside diameter of clamp (18)
and clamp location on link. Use dry cleaning
solvent (E162).
NOTE
Clamp (18) is to be positioned on full
outer diameter of link. Not on taper
end.
15.
With 38 , position clamp (18) on end of full O.D.
of link.
16.
With 38 , install electrical lead (19), bolt (21), two
washers (20), and nut (22) on clamp (18).
Sealant (E342.1) can irritate skin and
cause burns. Avoid contact with skin,
eyes, or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
17.
With 38 , seal clamp (18) edge around O.D. of
link with sealant (E342.1). Wear gloves (E184.1)
Allow sealant to air dry for a minimum of 6 hours
at 70º to 80º F (21º to 27ºC).
NOTE
If connecting link has any change
in length, perform neutral rig check
(Task 11-33).
INSPECT
FOLLOW-ON MAINTENANCE:
Connect servocylinder connecting links (Task
11-193).
Remove safety blocks (Task 11-29).
Perform functional check of tunnel controls (TM
55-1520-240-T).
Close tunnel access doors (Task 2-2).
Remove hydraulic power.
Remove electrical power.
END OF TASK
11-926
