TM 55-1520-240-23-9
11-205.2
REPLACE LCT ACTUATOR MOTOR
(Continued)
11-205.2
3.
Break the sealant bead and carefully lift motor (5)
straight up until red and green wires are exposed.
4.
If wires are crimped, cut as close to crimp as
possible. If wires are soldered, use soldering
gun to unsolder them.
5.
Remove motor (5).
6.
Remove old sealant from motor mounting pad
(6).
INSPECT
7.
Crimp wires from actuator (1) to serviceable
motor (5). Red to red, green to green.
8.
Clean motor mounting pad (6). Use naphtha
(E245.)
8.1.
Spray motor mount pad (6) with primer (E292.1).
9.
Apply adhesive (E49.1) to base of motor (7).
NOTE
During installation of motor (5), be
sure that data plate (8) faces away
from actuator (1).
10.
Install motor (5). Use screws (3) and washers (4).
Check that wires are not pinched (actuator sits
flush). Torque screws to 28 to 35 inch-pounds.
11.
Lockwire screws (3). Use lockwire (E227).
INSPECT
FOLLOW-ON MAINTENANCE:
Install forward/aft LCT actuator on aircraft (Tasks
11-206 and 11-221).
Perform forward/aft LCT actuator operational check
(TM 55-1520-240-T).
END OF TASK
11-820
